I am using Patch and Compliance in order to install IE though my company. The installer works great and I am able to monitor the installs as they go. I have my install set to "noReboot" and "passive" but with any IE install it does not alert the user to reboot once finished therefor just leaving the user to reboot without knowing for sure if IE was installed. I have a VBS that i want to run after "Run an executable" in the same task. It's a simple script that will display a prompt for the user if they want to reboot with a Yes to reboot and no to cancel. The problem that I am running into is that the script does not run after the install, IE does install but then I see a failed install results.
Am i doing something wrong were I enter the script,should I be going about this a different route?
I have attached the script as well along with a picture of were I enter this option
Notes
Using Patch Manager to Install IE
Want to Run Script that shows Prompt to Reboot after IE10 is finished within the same task
Script does not Run when entered with Patch install Commands "Run Script"
IE installs but shows Error on LANDesk Side with no "Prompt To Reboot" from script